There's an incredible amount of radio signals.
It's impossible to know them all let alone recognize them.
So why not get help from SignalID?
At the moment it recognizes about twenty signals (the exhaustive list is below)
With only 5 seconds of recording time it tries to recognize the signal.
To use it:
Set the frequency and bandwidth properly.
Selecting the frequency range. (0-30 MHz / Other)
Place the microphone of the telephone near the loudspeaker. (The quieter the environment is around the fewer errors will occur)
Press the big button that dances.
Wait 5 seconds. (minimum time required for recognition)
But the optimal and maximum time is 30 seconds.
Tips :
The algorithm is based on frequency a wrong tuning of your radio/SDR will result in an erroneous detection.
The recording is limited to 30 seconds for practical reasons.
Recognition of a signal may require several attempts.
If you notice bugs have remarks or suggestions please leave a comment.
Here is the non-exhaustive list of recognized signals :
- RTTY (Commercial 85Hz 170Hz 450Hz 850Hz Amateur 170Hz)
- STANAG 4285 (GEN SYS3000 FEC 8PSK TFC IDLE SYS3000)
- FT4
- FT8
The app is open source !
https://github.com/Neosama/SignalID
It's impossible to know them all let alone recognize them.
So why not get help from SignalID?
At the moment it recognizes about twenty signals (the exhaustive list is below)
With only 5 seconds of recording time it tries to recognize the signal.
To use it:
Set the frequency and bandwidth properly.
Selecting the frequency range. (0-30 MHz / Other)
Place the microphone of the telephone near the loudspeaker. (The quieter the environment is around the fewer errors will occur)
Press the big button that dances.
Wait 5 seconds. (minimum time required for recognition)
But the optimal and maximum time is 30 seconds.
Tips :
The algorithm is based on frequency a wrong tuning of your radio/SDR will result in an erroneous detection.
The recording is limited to 30 seconds for practical reasons.
Recognition of a signal may require several attempts.
If you notice bugs have remarks or suggestions please leave a comment.
Here is the non-exhaustive list of recognized signals :
- RTTY (Commercial 85Hz 170Hz 450Hz 850Hz Amateur 170Hz)
- STANAG 4285 (GEN SYS3000 FEC 8PSK TFC IDLE SYS3000)
- FT4
- FT8
The app is open source !
https://github.com/Neosama/SignalID
Show More >